Intel E1000E 网卡高负载断流

查看 8|回复 0
作者:lx01xsz   
设备是 NUC8beki5 ,装了 PVE 。网卡在网络 IO 高负载时会发生问题,syslog 如下。
现象 1: NUC 网络连接中断,等待几十秒-几分钟后恢复
现象 2: 协商速率由 1000MB/s 变为 100MB/s ,手动设置为 1000MB/s 后恢复 (网卡和路由器都支持千兆)
Jan 27 23:35:35 pve kernel: e1000e 0000:00:1f.6 eno1: NIC Link is Down
Jan 27 23:35:35 pve kernel: vmbr0: port 1(eno1) entered disabled state
Jan 27 23:35:42 pve kernel:  connection1:0: ping timeout of 5 secs expired, recv timeout 5, last rx 10254116869, last ping 10254121984, now 10254127104
Jan 27 23:35:42 pve kernel:  connection1:0: detected conn error (1022)
Jan 27 23:35:48 pve pvestatd[1233]: status update time (19.582 seconds)
Jan 27 23:36:12 pve kernel: e1000e 0000:00:1f.6 eno1: NIC Link is Up 1000 Mbps Full Duplex, Flow Control: Rx/Tx
Jan 27 23:36:12 pve kernel: vmbr0: port 1(eno1) entered blocking state
Jan 27 23:36:12 pve kernel: vmbr0: port 1(eno1) entered forwarding state
Jan 27 23:36:14 pve iscsid[3627392]: connection1:0 is operational after recovery (3 attempts)
Jan 27 23:36:37 pve pvestatd[1233]: status update time (19.299 seconds)
Jan 27 23:36:38 pve kernel: sd 4:0:0:0: Power-on or device reset occurred
驱动版本信息:
root@pve:~# ethtool -i eno1
driver: e1000e
version: 6.8.12-4-pve
firmware-version: 0.4-4
expansion-rom-version:
bus-info: 0000:00:1f.6
supports-statistics: yes
supports-test: yes
supports-eeprom-access: yes
supports-register-dump: yes
supports-priv-flags: yes
已经尝试更换网线并按照下面两个帖子的建议关闭了 tso
https://forum.proxmox.com/threads/e1000e-network-issue-on-proxmox.139141/
https://forum.proxmox.com/threads/e1000-driver-hang.58284/page-8#post-390709
但在持续高负载时还会出现上述问题,这个问题是在用 Rsync 恢复备份的时候发现的,尝试用 --bwlimit 限制 Rsync 到 50M, 40M, 30M 。
但均无法解决问题,难道只有硬改网卡了吗?
您需要登录后才可以回帖 登录 | 立即注册

返回顶部